IEEE 2715-2023
$39.54
IEEE Guide for the Characterization of the Shielding Effectiveness of Planar Materials (Approved Draft)
Published By | Publication Date | Number of Pages |
IEEE | 2023 |
New IEEE Standard – Active. A set of standard methods and procedures for determining the shielding effectiveness of planar materials is provided. Such materials might comprise, but are not limited to, metals, coated plastics, fiber-filled polymers, textiles, and coated fabrics. The selection of the appropriate test method to determine the level of shielding provided in the intended application, to provide a basis for comparing the measuring results, is considered. Emphasis is placed on those measurement techniques that have been adopted through incorporation into standards, both commercial and military, or that have been used extensively in practice.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 2715™-2023 Front cover |
2 | Title page |
4 | Important Notices and Disclaimers Concerning IEEE Standards Documents |
8 | Participants |
9 | Introduction |
10 | Contents |
11 | 1. Overview 1.1 Scope 1.2 Background |
12 | 1.3 Word usage 2. Normative references 3. Definitions, acronyms, and abbreviations 3.1 Definitions |
13 | 3.2 Acronyms and abbreviations |
14 | 4. Factors affecting the shielding effectiveness (SE) of planar materials |
17 | 5. Standardized SE measurement techniques ASTM D4935–18 |
20 | 6. SE measurement techniques derived from standardized techniques 6.1 ASTM D4935–18—high-frequency variants |
21 | 6.2 IEEE Std 299-2006 (based on the obsolete MIL-STD-285 [B22]) |
23 | 6.3 Reverberation chambers (RCs) |
28 | 7. Non-standardized SE measurement techniques 7.1 General 7.2 Far field TEM-t fixture |
30 | 7.3 Near field (NF) H-t fixture |
31 | 7.4 Dual TEM |
32 | 7.5 Waveguide |
33 | 7.6 “Quasi-optical” bench |
35 | 7.7 Absorber box |
37 | 8. Selecting an SE measurement technique 8.1 General 8.2 Material type |
38 | 8.3 Sample fabrication and reference samples 8.4 Sample configuration 8.5 Frequency range |
39 | 8.6 Dynamic range (DR) 8.7 Other considerations 9. Repeatability and measurement uncertainty 9.1 Repeatability |
41 | 9.2 Measurement uncertainty 10. Test plan 10.1 General 10.2 Test plan parameters to be defined 10.3 Calibration 10.4 DR |
42 | 11. Technical report 11.1 General 11.2 Status letter 11.3 Full test report |
45 | Annex A (informative) Summary of measuring techniques for planar materials |
49 | Annex B (informative) Shielding theory |
53 | Annex C (informative) Bibliography |
56 | Back cover |