BS EN ISO 8503-3:2012
$102.76
Preparation of steel substrates before application of paints and related products. Surface roughness characteristics of blast-cleaned steel substrates – Method for the calibration of ISO surface profile comparators and for the determination of surface profile. Focusing microscope procedure
| Published By | Publication Date | Number of Pages |
| BSI | 2012 | 22 |
This part of ISO 8503 specifies the optical microscope and describes the procedure for calibrating ISO surface profile comparators conforming to the requirements of ISO 8503-1.
This part of ISO 8503 is also applicable to the determination of the surface profile, within the range = 20 μm to 200 μm, of essentially planar blast-cleaned steel. The determination can be carried out on a representative section of the blast-cleaned substrate or, if direct observation of the surface is not feasible, on a replica of the surface (see Annex E).
NOTE Where appropriate, this procedure can be used for assessing the roughness profile of other abrasive blast-cleaned substrates.
An alternative procedure is described in ISO 8503-4.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions 4 Principle |
| 10 | 5 Apparatus 6 Test surfaces 6.1 ISO surface profile comparator 6.2 Blast-cleaned steel substrates/replica 7 Procedure for measurement of maximum peak-to-valley height |
| 11 | 8 Calculation and expression of results 9 Test report |
| 13 | Annex A (normative) Determination of backlash (play) in the microscope adjustment mechanism |
| 14 | Annex B (normative) Test report for the calibration of ISO surface profile comparators and for the determination of surface profiles |
| 15 | Annex C (normative) Form for recording surface profile measurements made in accordance with this part of ISO 8503 |
| 16 | Annex D (informative) Guidance notes for calibrating ISO surface profile comparators using a focusing microscope |
| 18 | Annex E (informative) Guidance notes for the preparation and measurement of replicas |
| 19 | Bibliography |
Related products
-
ISO 8503-3:2012
Preparation of steel substrates before application of paints and related products — Surface roughness characteristics…
