Shopping Cart

No products in the cart.

ASTM-E2780 2010

$44.96

E2780-10 Standard Test Method for Determining Particulate Matter Emissions from Wood Heaters

Published By Publication Date Number of Pages
ASTM 2010 12
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This test method covers the fueling and operating protocol for determining particulate matter emissions from wood fires in wood-burning room heaters and fireplace inserts as well as determining heat output and efficiency.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
2 Summary of Test Method
Significance and Use
Safety
3 Equipment and Supplies
Calibration and Standardization
Procedure
5 FIG. 1
TABLE 1
TABLE 2
7 Data Analysis and Calculations
9 Precision and Bias
Keywords
A1. CORDWOOD FUELING AND OPERATION
A1.1 Scope
A1.2 Terminology
A1.3 Equipment and Supplies
A1.4 Calibration and Standardization
A1.5 Cordwood Test Fuel
TABLE A1.1
FIG. A1.1
10 A2. WOOD HEATER THERMAL EFFICIENCY AND HEAT OUTPUT DETERMINATION
A2.1 Scope
A2.2 Referenced Documents
A2.3 Summary of Test Method
TABLE A1.2
11 A2.4 Significance and Use
A2.5 Procedure
A2.6 Data Analysis and Calculations
X1. SINGLE BURN RATE APPLIANCE FUELING AND OPERATION
X1.1 Scope
X1.2 Terminology
TABLE A2.1
12 X1.3 Summary of the Test Method
X1.4 Procedure
X1.5 Data Analysis and Calculations
ASTM-E2780 2010
$44.96