ASTM-D705 2004

$35.75

D705-99(2004) Standard Specification for Urea-Formaldehyde Molding Compounds

Published By	Publication Date	Number of Pages
ASTM	2004	2

Guaranteed Safe Checkout

Categories: 83.140.99 - Other rubber and plastics products, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in .

1.2 The values stated in SI units are to be regarded as the standard.

Note 1

The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding.

The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2

ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Classification General Requirements Detail Requirements Sampling Test Methods
2	Packaging and Package Marking Keywords TABLE 1

Additional information

Standard Title	D705-99(2004) Standard Specification for Urea-Formaldehyde Molding Compounds
Published Code	ASTM
Publication Date	2004
Pages Count	2
ICS Codes	83.140.99 - Other rubber and plastics products

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D705 2004

PDF Catalog

Related products