Shopping Cart

No products in the cart.

ASTM-D4592 2005(Redline)

$23.40

D4592-05 Standard Specification for Preformed Retroreflective Pavement Marking Tape for Limited Service Life (Redline)

Published By Publication Date Number of Pages
ASTM 2005 4
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Abstract

This specification covers white or yellow preformed retroreflective pavement marking tapes that are designed to provide a service life of typically 3 to 6 months, on roads with up to 15 000 average daily traffic count (ADT). The tapes are intended for use as longitudinal, transverse, or word/symbol pavement markings that provide delineation day and night. The tapes may be either Type I (removable) or Type II (nonremovable). The marking tape shall be a reflective film coated with a pressure-sensitive adhesive with or without a protective liner. It shall be flexible and shall conform to the the typical road pavement surface. In addition, it shall adhere to asphalt or portland cement concrete roadway surfaces when applied. Also, the marking tape shall be retroreflective, reflecting white or yellow, respectively, and shall be readily visible when viewed with automobile headlights at night and shall have minimum reflective values as specified.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers white or yellow preformed retroreflective pavement marking tapes that are designed to provide a service life of typically 3 to 6 months, on roads with up to 15 000 average daily traffic count (ADT).

1.2 The tapes are intended for use as longitudinal, transverse, or word/symbol pavement markings that provide delineation day and night. The tapes may be either removable or nonremovable.

1.3 The values stated in SI units are to be regarded as the standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D1000 Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications D4061 Test Method for Retroreflectance of Horizontal Coatings

ASTM-D4592 2005
$23.40