ASTM-B737 2005
$35.75
B737-05 Standard Specification for Hot-Rolled and/or Cold-Finished Hafnium Rod and Wire
Published By | Publication Date | Number of Pages |
ASTM | 2005 | 4 |
1.1 This specification covers hot- or cold-worked hafnium rod and wire, or both.
1.2 This specification contains two material grades, one specifically for nuclear applications (Grade R1) and one for commercial applications for alloying (Grade R3).
1.3 The products covered include the following:
1.3.1 Rod 3/8 to 1 in. (9.5 to 25 mm) in diameter.
1.3.2 Wire less than 3/8 in. (9.5 mm) in diameter.
1.4 Unless a single unit is used, for example, corrosion mass gain in mg/dm 2 , the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. SI values cannot be mixed with inch-pound values.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents Terminology Ordering Information |
2 | Materials and Manufacture Metallurgical Condition Chemical Composition Mechanical Properties Corrosion Properties Permissible Variations in Dimensions Special Tests TABLE 1 TABLE 2 TABLE 3 |
3 | Finish Workmanship Number of Test and Retests Significance of Numerical Limits Inspection Rejection Referee Certification Packaging and Package Marking Keywords TABLE 4 |
4 | TABLE 5 |