ASTM-B241:2012 Edition(Redline)
$30.55
B241/B241M-12 Standard Specification for Aluminum and Aluminum-Alloy Seamless Pipe and Seamless Extruded Tube (Redline)
| Published By | Publication Date | Number of Pages |
| ASTM | 2012 | 22 |
This specification covers aluminum and aluminum-alloy seamless pipe and seamless extruded tube. The pipe and tube shall be produced from hollow extrusion ingot (cast in hollow form, or drilled, or pierced from solid ingot) and shall be extruded by use of the die and mandrel method. The material shall conform to the chemical composition requirements specified. The determination of chemical composition shall be made in accordance with suitable chemical (test methods E 34) or spectrochemical (test methods E 227, E 607, and E 1251) methods. Alloys may be solution heat-treated and quenched at the extrusion press in accordance with practice B 807 for the production of T4 and T6-type tempers, as applicable. The material shall conform to the tensile property requirements specified. The tension tests shall be made in accordance with test methods B 557. The stress-corrosion cracking test shall be performed on extruded tube. The stress-corrosion test shall be made in accordance with test method G 47. The aluminum alloy coating of clad tube shall comprise the inside surface (only) of the tube and its thickness shall be approximately 10 % of the total wall thickness of the tube.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification 2 covers aluminum and aluminum???alloy seamless pipe in the alloys ( Note 1 ) and tempers shown in Table 1 [ Table 2 ] and seamless extruded round tube in the alloys and tempers shown in Table 3 [ Table 4 ] intended for pressure applications. The standard sizes for seamless pipe are listed in Table 16.7 of ANSI H35.2 and H35.2M . Nonstandard alloys, tempers, and sizes of pipe are produced as seamless extruded tube.
<div class="footn
ANSI Standards
H35.2(M) Dimensional Tolerances for Aluminum Mill Products [Metric]
Federal Standard
Fed.Std.No.123 Marking for Shipment (Civil Agencies) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://dodssp.daps.dla.mil.
Military Standard
MIL-STD-129 Marking for Shipment and Storage
AMS Specification
AMS2772 Heat Treatment of Aluminum Alloy Raw Materials Available from SAE International (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.
CEN EN Standards
CENEN14242 Aluminum and Aluminum Alloys. Chemical analysis. Inductively coupled plasma optical emission spectral analysis Available from European Committee for Standardization (CEN), 36 rue de Stassart, B-1050, Brussels, Belgium, http://www.cenorm.be.
Keywords
aluminum alloy; seamless extruded tube; seamless pipe ;
ICS Code
ICS Number Code 77.150.10 (Aluminium products)
DOI: 10.1520/B0241_B0241M-12 ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
