🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
AS 1359.114:1997

AS 1359.114:1997

$16.25

Rotating electrical machines – General requirements – Vibration measurements and limits

Published By Publication Date Number of Pages
AS 1997-08-05 16
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Specifies vibration test procedures and limits for certain d.c. and three-phase a.c. machines at nominal speeds from 600 rev/min to 3600 rev/min. This Standard is identical to, and has been reproduced from, IEC 34-14:1996.

Scope

This part of IEC 34 specifies the vibration test procedures and limits for certain electrical machines under specified conditions, when uncoupled from any load or prime mover. It is applicable to d.c. and three-phase a.c. machines, with shaft heights 56 mm and higher and a rated output up to 50 MW, at nominal speeds from 600 rev/min up to and including 3600 rev/min. For vertical machines and flange-mounted machines, this standard is only applicable to those machines that are measured in a state of free suspension. This standard is not applicable to machines mounted in situ, three-phase commutator motors, single-phase machines, three-phase machines operated on single-phase systems, vertical water power generators, permanent magnet generators, or series-wound d.c. machines.
NOTE – For machines measured in situ refer to ISO 10816-1 (basic document).

Related products

AS 1359.114:1997
$16.25