BS EN ISO 20127:2020
$142.49
Dentistry. Physical properties of powered toothbrushes
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 26 |
This document specifies requirements and test methods for the physical properties of powered toothbrushes in order to promote the safety of these products for their intended use. There are different technologies of powered toothbrushes. Common features of those powered toothbrushes to which this document applies are: — a battery; — a motor; — a mechanical or magnetic drive system; — a moving brush head with tufted filaments. Powered toothbrushes can have a moving brush head with different motions (e.g. oscillating-rotating, side-by-side), frequencies and velocities. The requirements listed in this document apply to all types of powered toothbrushes. However, there is a possibility that some requirements are not applicable for all types, for example brush head plate retention can only be applied if the brush has a head portion that might get detached from the brush shaft. This document is not applicable to other types of powered oral hygiene devices (such as powered interdental brushes) or manual toothbrushes.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 4 | European foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | 4 Requirements 4.1 Physical inspection 4.2 Electrical safety 4.3 Tuft retention 4.4 Mechanical strength |
| 11 | 4.5 Resistance to chemical degradation 5 Sampling and pass-fail criteria 5.1 Sampling 5.2 Pass-fail criteria 6 Test methods 6.1 General test conditions 6.2 Visual inspection 6.3 Tactile inspection 6.4 Tuft retention 6.4.1 Apparatus |
| 12 | 6.4.2 Procedure 6.5 Brush head plate retention 6.5.1 Apparatus 6.5.2 Procedure |
| 13 | 6.6 Resistance to chemical degradation 6.6.1 Apparatus and chemicals 6.6.2 Procedure |
| 14 | 7 Test report 8 Marking and labelling 8.1 Powered toothbrush components 8.2 Instructions for use 8.3 Marking and labelling 9 Packaging |
| 15 | Annex A (informative) Gripping device for tuft retention test |
| 17 | Annex B (informative) Gripping device for brush head plate retention test |
| 25 | Bibliography |
